17 Products
The HT Thru Tie Rod is manufactured from high grade steel and features a special 'high speed' thread to reduce the time and cost of erecting and dismantling the HT Thru Tie assembly. Tie Rods need…
Wing Nut is designed to spin freely on the 'high speed' thread by hand and may be tightened using either an AF spanner or a length of bar. The unbalanced, single wing design resists movement under…
Rod Couplers can be used to join HT Thru Ties where greater lengths are required (or for economical use of cut lengths). The Rod Coupler remains buried in the concrete. The HT Thru Tie Rod MUST be…
The HT Thru Tie Rod is manufactured from high grade steel and features a special 'high speed' thread to reduce the time and cost of erecting and dismantling the HT Thru Tie assembly. Tie Rods need…
Wing Nut is designed to spin freely on the 'high speed' thread by hand and may be tightened using either an AF spanner or a length of bar. The unbalanced, single wing design resists movement under…
Rod Couplers can be used to join HT Thru Ties where greater lengths are required (or for economical use of cut lengths). The Rod Coupler remains buried in the concrete. The HT Thru Tie Rod MUST be…
The HT Thru Tie Rod is manufactured from high grade steel and features a special 'high speed' thread to reduce the time and cost of erecting and dismantling the HT Thru Tie assembly. Tie Rods need…
The design of the Acrow Flexi-Fillet provides a range of uses from forming chamfers on all types of formwork to flexible drip or bead moulds. Extremely durable Acrow Flexi-Fillet is hard wearing and…
Bullet Head Nails - available in the following sizes: 30mm x 1.8mm - 2kg pack 50mm x 2.8mm - 15kg pack 75mm x 3.15mm - 15kg pack 75mm x 3.75mm - 15kg pack
Hex Couplers can be used to join metric threaded steel rods where lengths are required (or for economical use of cut lengths). The Hex Coupler remains buried in the concrete. The Hex nut MUST be…
Lanotec is a natural, biodegradable, and environmentally friendly formwork release agent made from Lanolin. It lubricates and protects formwork, pre-cast and tilt panes and falsework scaffolding…
Removable after use. These 'push- fit' Polythene Cones fit on the ends of the PVC Tube Spacer. Available in two sizes to suit the 24.5 and 27.0mm OD spacer tube. The plastic cone leaves a clean-edge…
The expendable PVC Tube Spacer is available in 2 diameters 24.5 OD to suit the 15/17mm Thru Tie Rod. 27.0 OD to suit the 19/21mm Thru Tie Rod. 3m lengths - 10 lengths per pack (30m)
An internal water seal for spacer tubes. This soft PVC based material is resistant to Saline Solutions, Diluted Alkaline Solutions, Soap Suds and Ammonia Water. The Flupp 22ST is also conditionally…
Powered by